UNICAN IMMOBILIZER EMULATOR PROGRAM FOR FIAT / IVECO ECUs COMMUNICATING THROUGH CAN BUS ON 50/250/500 Kbps.
For proper operation, we need to program the CAN speed at which the ECU operates and the 6-byte synchronization code from the ECU.
In the cell at address 0x01, we enter CAN bus speed values of 50, 25, or 05, which correspond to 500 Kbps, 250 Kbps, or 50 Kbps, respectively.
In the cell at address 0x02, we have a value of 0xFF which sets automatic recognition of the type of immobilizer library used in the ECU.
In cells starting from address 0x10, enter the 6 bytes of synchronization code from the ECU that we intend to unlock.
When providing technical support, we help customers to determine the synchronisation code.
An example synchronisation code: A5 A5 A5 A5 A5 A5, is factory programmed into the UNICAN emulator.
In the case of many types of FIAT ECUs, appropriately restoring the ECU to a 'virgin’ state will result in the data from the emulator being rewritten to the controller during the auto-adaptation procedure when the power is switched on.
Four wires should be connected: CAN-H, CAN-L, GND (ground) and +12 V IGN ( terminal „15”) or +12 V after the ECU/ECM relay. Ensure the connection adheres to the vehicle’s repair schematics.
The colors of the corresponding wires are specified in the photo.
The location of the eeprom 24C02 memory is also specified in the photo.
Please remember the CAN terminator – terminator resistor, is in many cases indispensable especially when the ECU works standalone.
The description of the green and red LEDs can be found in the photo, thanks to them we can carry out diagnostics of the emulator connection, they clearly indicate the current status of the CAN bus connection and the status of matching to the ECU.
Example of the use of the UNICAN emulator in the DELPHI DCM7.1B ECU with the FIAT immobilizer library.
In the case of IVECO vehicles – the emulator works with vehicles with an immobiliser integrated into the BSI module.
When installing the emulator in vans: DUCATO, JUMPER, IVECO and FIAT derivatives, it may be necessary to disconnect the immobilizer coil located in the ignition switch.
EXAMPLE VIDEO USAGE UNICAN EMULATOR ON IVECO EDC17CP52 ECU
EXAMPLE VIDEO USAGE UNICAN EMULATOR ON DUCATO DCM7.1B ECU
In order to use this solution, the customer must be qualified as an automotive electronics technician and have the necessary diagnostic tools and wiring diagrams.
In the event of problems and the need for technical support, a CAN bus analyzer will be required in addition to the ECU files, as well as the ability to operate it.